How to sew a round dog bed with sides? - briefly
To create a round dog bed with sides, start by measuring and cutting two circles of fabric for the base and top, as well as a strip for the sides. Sew the side strip to the base circle, right sides together, creating a tube. Turn it right side out, then attach the top circle, sewing all layers together.
How to sew a round dog bed with sides? - in detail
To create a comfortable and stylish round dog bed with sides, follow these detailed steps:
-
Materials Needed:
- Fabric for the outer cover (e.g., durable cotton or polyester)
- Fabric for the inner lining (optional but recommended for easy cleaning)
- Stuffing material (e.g., foam, batting, or old clothes)
- Sewing machine and matching thread
- Scissors or fabric shears
- Marking tool (chalk or fabric pen)
- Ruler or measuring tape
- Pins
-
Measurements: Measure your dog to determine the size of the bed. A common approach is to measure from the tip of the nose to the base of the tail and add a few inches for comfort. The height of the sides can vary but typically ranges from 4 to 6 inches.
-
Cutting the Fabric:
- Outer Cover: Cut two circles from the outer fabric, one for the top and one for the bottom. Use a compass or trace around a large bowl to ensure accuracy. The diameter should be slightly larger than your dog's length measurement.
- Sides: Cut strips of fabric for the sides. The width of each strip should be equal to the desired height of the sides plus 1 inch for seam allowance. The length of each strip will depend on the circumference of the circle, which can be calculated using the formula (C = \pi \times d), where (d) is the diameter.
- Inner Lining: If using an inner lining, cut two smaller circles from the lining fabric and set them aside.
-
Sewing the Sides:
- Pin one of the side strips to the edge of the bottom circle, right sides together. Sew along the edge with a ½-inch seam allowance. Repeat this process with the remaining side strips, spacing them evenly around the circle.
-
Attaching the Top Circle:
- With the right side of the top circle facing up, pin and sew each side strip to the edge of the top circle, using a ½-inch seam allowance. Leave an opening of about 3 inches for turning the bed right side out later.
-
Adding the Inner Lining (Optional):
- If you are using an inner lining, place the two lining circles together with wrong sides facing. Sew around the edge with a ½-inch seam allowance, leaving a small opening for turning. Turn the lining right side out and press.
-
Assembling the Bed:
- Insert the stuffed inner circle into the outer cover through the opening in the top circle. Make sure to align the sides properly. If using an inner lining, insert it between the stuffing and the outer cover.
-
Finishing Touches:
- Sew the 3-inch opening closed by hand or with a sewing machine. You can also add a zipper for easier access to the stuffing if desired.
- Fluff up the bedding material to achieve an even and comfortable surface.
-
Final Check: Ensure that all seams are secure and that there are no loose threads or sharp edges. Your dog's new bed should now be ready for use!